The dreaded s/pdif problem again...

[Zappos]

Hi guys,

I have just downloaded v1.1 build 814 and I must say this program seems great :D . Far better than VLC Media player that I had been using. However, I have this s/pdif problem. I have read all the posts and replies that I can find on this subject but they all refer to ealier versions. Also, I have tried everything mentioned and still get the same problem.

If I play a file from say, PowerDVD, my AV Amp shows Digital input. If I run it from BSplayer, it shows PCM. I cannot seem to enable the s/pdif output from the preferences. I have downloaded and registered the InterVideo codec but the check box will not remain checked.

I have also downloaded and installed the AC3Filter from sourceforge but I still get the same problem altough the filter does show the input is AC3 5.1 and show the levels so the source is ok.

I have been at this all morning and must confess I am running out of patience! I was going to register but will hold off for a while. No point if I cant get digital

Can someone please advise a solution?