Edit ac3 filter properties in bsplayer

[Dr_digitaL]

hello I downloaded the AC3Filter ver 0.68b and would like to know how to edit the filters properties within bs player. The instructions that came with the ac3 filter state: Filter can be configured with several ways. Best is if player allow to call filter properties (WMP 6.4, BSP, Sasami, etc, not in WMP 7, 8, 9!)
or is this even possible with the bs player???

it also states: If player does not allow to reach filter settings it is possible to configure it from Start menu with 'AC3Filter Config' icon or Control Panel icon. But this method do not show current activity and do not affect it! I.e. levels will not change, bitstream information will be filled with zeros etc. Moreover all players should be closed (because when player is closing filter saves its configuration to registry, so now configured values may be overwrited with old values that was read at player startup). So it is highly recommended to configure filter from within player that allow access to filter properties (almost any of widespreaded: BSPlayer, Sasami, ZoomPlayer, LightAlloy, etc).
This is a option that i would rather not take if possible

[charlystone]

Hi man.
Click on the play window with right mouse button, go to properties - AC3 filter.

[Dr_digitaL]

the only audio options that i see when i right click on the screen and go to properties is mpeg layer 3 decoder

[bisterfinnen]

Try to klick "change menu" first (on top), then settings, settings... or just click "ctrl + p"

Remember that there is arrows in the top right corner. General is the first left menu.

Pls tell me how it went!

Regards

Stefan

[charlystone]

A use this way to configure my AC3 filter properties for a while. If it does not work by you, you probably do not have configured bsplayer and/or ac3 filter properly.

check this:

http://forum.bsplayer.org/viewtopic....270f5214f#3637